While turning off the air induction valve may vary based on your tub manufacturer (always check the manual), general advice is to adjust the jets fully clockwise to turn off air induction. There is usually an “OFF” indicator on the air induction valve that will indicate the direction you need to turn the jets.
Contents
- 1 Where is the air intake valve on a jetted tub?
- 2 What is an air induction valve?
- 3 How do I reset my jetted tub?
- 4 How do you turn off an air induction valve?
- 5 How do you close an air induction valve?
- 6 What are the knobs on my jetted tub?
- 7 How do I turn off the water to my Jacuzzi tub?
- 8 Is air induction service necessary?
- 9 How do I turn on the jets in my Jacuzzi tub?
- 10 Why won’t my Jacuzzi bathtub jets turn on?
Where is the air intake valve on a jetted tub?
The air intake valves of your Jacuzzi are usually located at the bottom of the tub. The intake valves are usually protected with a fine mesh screen to keep debris and foreign particles out of the valve.
What is an air induction valve?
The air induction system consists of the air cleaner, air flow meter, throttle valve, air intake chamber, intake manifold runner, and intake valve. Air delivered to the engine is a function of driver demand. As the throttle valve is opened further, more air is allowed to enter the engine cylinders.
How do I reset my jetted tub?
How Do I Reset a Jetted Spa?
- Drain the water using the main control panel and turning the valves below.
- Turn your spa off using the main control panel.
- Clean the spa completely, paying special attention to the jets and filter.
- You will find a reset button typically on the heater unit.
How do you turn off an air induction valve?
While turning off the air induction valve may vary based on your tub manufacturer (always check the manual), general advice is to adjust the jets fully clockwise to turn off air induction. There is usually an “OFF” indicator on the air induction valve that will indicate the direction you need to turn the jets.
How do you close an air induction valve?
Turn off the air induction valves by turning them fully clockwise. This forces the water to circulate only in the internal plumbing of the tub to concentrate the flow and clean deeper. Leave them open if the manufacturer of your tub states to do so in the owner’s manual.
What are the knobs on my jetted tub?
Water Control Generally, in the form of manual knobs, there are electric versions, but the idea is that the water knobs control the speed and pressure of the jets. Some of these are tied and linked to your electric water pump.
How do I turn off the water to my Jacuzzi tub?
It wasn’t always required to put cut-offs on tubs, tho I think it may be now. You may be able to look thru your access panel (which I bet is only for the motor?) and see the piping. Is this also set up as a shower? If you have a good faucet, there may be cut-offs built in, behind the trimplate.
Is air induction service necessary?
A fuel induction service is typically not part of the mileage-based maintenance schedule in your owner’s manual. That said, it should still be part of your car maintenance routine. We recommend it every 60,000 miles or whenever you notice performance issues.
How do I turn on the jets in my Jacuzzi tub?
Press the “On/Off” control on the side of the tub to turn on the pump and start the whirlpool jets. Wait for up to a minute while the pump primes. Once the pump is primed, the jets will activate.
Why won’t my Jacuzzi bathtub jets turn on?
When jets start failing, the most likely case is that your hot tub pump is not working correctly. Open the access panel and the airlock valve close to the pump. This releases air from the line and purge system, allowing more water to stream through the jets. Clogged filters or water intakes can also cause jet issues.
