How Do You Remove A Vandal Proof Tap Handle?

Vandal proof taps require a special type of spanner to undo the nut at the base of the handle. Try the FIX-A-LOO indoor tap spanner and nuts. If you still have problems, try using some form of lubricating oil such as WD40, or consult your local plumber who will be able to remove it for you.

How do you remove vandal proof taps?

How can I remove stuck anti-vandal rings in tap head?

1. Using an anti-vandal tap head spanner (shown below), but the prongs bend/break, as the screws are quite stuck.
2. Using a hair-dryer to heat up the ring before using the spanner.
3. Adjusting the rings to tighten, then to loosen.
4. Applying WD-40 to the rings.

How do you remove tap handles without screws?

If you can’t have it out with your plain hands, try using a pair of pliers or faucet handle puller. Pliers can scratch your faucet’s handle if applied directly. Wrap an old cloth or towel around the handle’s base then use the pliers. After removing the handle, you may find some mineral deposits.

Can’t get bathroom faucet handle off?

If it’s stuck, wrap a rag around it, give it a few light taps with a hammer and try again. Squirt a few drops of penetrating oil or spray lubricant into the space between the handle and the valve stem. Wait a few minutes, then tap the handle and try pulling it off. Place a scrap piece of wood on the faucet body.

How do I remove a stuck Kohler faucet handle?

Hold the faucet lever. Grab and twist the skirt under the lever and twist clockwise (as looking down at the handle). If it’s tight, try using a rubber jar opener to loosen it. If really tight, use a strap wrench (I found one at Sears for under $6) to loosen.

How do you remove a corroded faucet handle?

Heat the corroded part of the faucet with a hairdryer if it won’t turn. The metal swells as it heats up, and this can loosen or break the bond caused by the corrosion. Again, try to turn the part with the wrench. Let the metal cool off if the part is still stuck.

How do you remove a single faucet handle?

Single-Handle Bathroom Sink Faucets – Handle Removal

1. Using a bladed screwdriver, gently pry off the plug button under the handle, taking care to protect all finished surfaces.
2. Using a 1/8″ hex wrench, loosen the setscrew securing the handle to the valve stem.
3. Lift off the handle.
4. Unthread the bonnet to expose the valve.