Can You Staple Cedar Shingles?

The Cedar Shake & Shingle Bureau prefers the use of nails, however if you choose to use staples they must be stainless steel Type 316 in locations within fifteen (15) miles of salt water. For locations outside of the salt water zone – stainless steel staples Type 304 or Type 316 must be used.

Can you use a staple gun with cedar shingles?

“Use either rust-resistant staples or shingle nails (1-1/4” to 1-1/2” long), galvanized, in stainless steel or aluminum”. It simply means that the best nail gun for cedar shingles will either be a stapler nail gun or any nailer that can shoots the recommended nails or staples!

Can you put shingles on with staples?

Fasteners for asphalt shingles should be roofing nails or staples. Both nails and staples have sufficient strength to resist small uplift load on the shingles, as long as the tabs remain sealed. If staples are properly installed, they offer nearly the same wind resistance as nails.

Can you use galvanized staples in Cedar?

Choose hot-dipped galvanized number 304 stainless steel nails that are about 1 1/4 inches longer than the thickness of your cedar fencing. The Western Red Cedar Association (WRCA) recommends these nails for your fencing jobs, since other types of nails will rust quickly and leave black streaks below each nail point.

You might be interested:  Quick Answer: Can Olives Grow In Florida?

What type of fastener do you use on cedar shingles?

The Cedar Shake & Shingle Bureau prefers the use of nails, however if you choose to use staples they must be stainless steel Type 316 in locations within fifteen (15) miles of salt water. For locations outside of the salt water zone – stainless steel staples Type 304 or Type 316 must be used.

Can I use 1/4 crown staples for cedar shingles?

The following are a few recommendations to help ensure their lasting beauty. Exposure: To prevent buckling, use a 5” (12.7 cm) maximum exposure. Fasteners: Rust-resistant (galvanized, aluminum or stainless) nails or staples, 1 1/4” to 1 1/2” (3.2 to 3.8 cm) long.

What staples for shingles?

Staples made of at least 16-gauge galvanized steel with a minimum crown of 15/16” (24 mm) have been and continue to be used by some applicators to install shingles.

Should cedar shingles be sealed?

No. Never seal your cedar roof. Sealing the roof will lock in moisture that would otherwise naturally evaporate during normal weather conditions. Cedar needs to breathe and thus a water repellant type product, rather than a water proofer is the best route to follow.

Can you use screws on cedar siding?

Do not use common nails or screws. Use of these will lead to eventual bleeding of rust over time, causing an unsightly stain in the cedar siding. Use only hot dipped galvanized, aluminum, or stainless steel nails or screws when fastening Western Red Cedar.

What size staples cedar shingles?

According to my research, there are two best-practice options: shingle nails or air-driven staples measuring 7/16” wide. Stainless steel fasteners are always optimal for exterior applications because they never rust, but finding shingle-friendly fasteners in these configurations isn’t easy.

You might be interested:  Question: Does Canned Paint Go Bad?

How many staples are in a square of cedar shingles?

Use 2 fasteners per shingle at about 3/4” (1.9 cm) from each edge, and at 1” (2.5 cm) above the butt-line of the overlapping shingle. If shingles are wider than 8” (20.3 cm), use 2 additional fasteners driven 1” (2.5 cm) apart near the center of the shingles.

Written by

Leave a Reply

Adblock
detector