A soft-close hinge is a type of hinge that features a hydraulic mechanism built into it. When you close the cabinet door, the hydraulics take charge and ease the door closed in complete silence in somewhat of a gliding motion. Soft-close movement systems made by Grass allow for quiet and effortless closing action.
Contents
- 1 How do self close hinges work?
- 2 Can you adjust the tension on soft close hinges?
- 3 Why is my soft close hinge not working?
- 4 Do both hinges need to be soft close?
- 5 Is Soft Close same as self close?
- 6 What is the point of soft close doors?
- 7 What makes a cabinet soft close?
- 8 Why does my soft close drawer slams shut?
- 9 How do you adjust the tension on a soft close drawer?
- 10 How do I make my door soft close?
How do self close hinges work?
One specific model of self closing door hinges, uses the friction caused by opening the door to pull a spring. This spring uncoils as the door is opened, and when you let go, the spring closes the door by pulling back to its natural state.
Can you adjust the tension on soft close hinges?
Take a moment to focus on the soft close hinge and find the adjustment tab. Look for gray or silver plunger in the center of the hinge. To confirm that it’s the adjustment tab, try pulling on it with the tip of your finger.
Why is my soft close hinge not working?
Self-closing cabinet hinges that won’t close might be poorly adjusted. The cabinet door might overlap the neighboring door, be crooked or sit too far out from the cabinet face. Or, the door could be set too far out from the cabinet face, shortening the amount of time the soft-close hinge has to slow down the door.
Do both hinges need to be soft close?
In general one soft hinge is sufficient on majority of the door and closing habits. However, if you close the door normally, or even with slightly harder manner than usual, one and two soft hinges would give you identical results. So, save your money.
Is Soft Close same as self close?
There is a difference in soft close and self close. Self close means when you close the door and it get within 2″ of closing, it will pull itself close because of the spring in the hinge itself. Soft close would be that the door gets about 2″ away from closing, and then slows itself to softly close.
What is the point of soft close doors?
Soft-close doors were introduced on mainstream automobiles as early as the 1990s, but it’s a system that has been used on cabinets and housing doors long before that. Its main purpose is to prevent doors from being slammed and reduce the risk of damaging the door itself and other surfaces it may get in contact with.
What makes a cabinet soft close?
The soft close hinge helps to reduce the force of how you close your cabinet doors. It reduces the speed at which the door closes so it does not shut with a bang. You can get a conversion kit to do your soft close. These kits typically come with a damper, screws, and spacer.
Why does my soft close drawer slams shut?
The primary reason for self-closing drawer failure is improperly installed guides or a drawer that was built out of square. This can cause the drawer to skew to one side and fail to close all the way. You can adjust this type of drawer using only a screwdriver.
How do you adjust the tension on a soft close drawer?
Adjusting soft close drawers are easy. Adjust your under mount soft close drawer by moving the adjustment knob in the corner of the drawer clip. Use this knob to fine-tune the space between the drawer fronts. This can be done while the drawer is installed.
How do I make my door soft close?
Try a few felt pads. Just stick a few small felt pads along the edge of the doorframe: Position a pad at the top and bottom of the frame, along with two more pads at the top and bottom of the strike plate. The pads provide just enough soft cushioning to slow down the door as it closes, preventing a slam.
