Often asked: What Is Zeolite Sand?

ZeoSand is a 100% natural zeolite and a highly efficient filter media that is proven for use as a sand replacement in recreational water, drinking water, and industrial applications. ZeoSand’s huge surface area which is more than 100 times greater than sand traps more and finer dirt than sand.

Is zeolite sand better?

The main advantage of Zeolite over sand is that it produces a cleaner, safer, higher quality water. The removal of nutrients will also be beneficial as they are a common cause of bad taste in water. Zeolite is the only filter media that actually removes Ammonia from pool water and filters significantly finer than sand.

Is zeolite sand safe?

Zeolite is a natural and safe mineral found in volcanic rocks. You will also not have to backwash your pool quite as often when using Zeolite sand. This can be a nice benefit allowing more time between each backwash.

How long does zeolite sand last?

Zeolite is also supposed to last 5-7 yrs as opposed to the 3-5 of silica sand.

What type of sand should I use in my pool filter?

The most commonly used pool filter sand is #20 silica sand. It comes from ground quartz, which creates sharp silica grains with jagged edges excellent for trapping particulates from passing water.

Can you mix sand and zeolite?

No mix and match.

How often do you replace zeolite?

Zeolite must be replaced once every 3 to 5 years.

Is ZeoSand better?

ZeoSand filters out particles as small as 2-5 microns. Traps ammonium ions responsible for chloramine formation. Lasts longer than sand and requires 50 percent less backwashing. Use 50 percent less ZeoSand than you would silica sand.

How much Zelbrite do I need?

How much Zelbrite do I need in my filter? Zelbrite has a lower bulk density than sand, hence you require 75% by weight of the amount of sand required, and this will vary depending on the size of the filter. A 15kg bag of Zelbrite is equivalent in volumer to a 20kg bag of sand.

What is pool sand called?

The sand that lies underneath your pool is called “ mason sand”, while the sand for your filter is simply called “filter sand” or “silica sand”.

How much does pool salt cost?

The overall cost of salt for a saltwater pool will vary by the type of salt that you use and the size of your pool, but you can expect to pay on average between $10 and $25 per every 40 pounds of salt (or 25¢ to 63¢ per pound of salt). Some brands may even sell a 40-pound bag of pool salt for as much as $40.

Is pool sand silica sand?

Most play sand is made of quartz, also known as silica. There are also play sands which are silica free, so they contain other minerals such as feldspar instead. Pool filter sand is exclusively made up of silica. Silica is very effective at removing impurities from pool water.

Can you use beach sand in a pool filter?

The Bottom Line Beach sand and play sand may introduce contaminants and insects into your pool, as well, and are much more likely to travel out of the filter and into the pool itself. If you use the proper sand, you will only need to replace your filter sand once every 5 to 15 years, depending on your water conditions.

Can you have too much sand in a pool filter?

Too much sand and your filter will likely not run correctly or may break when reassembling. Too little sand and you will have cloudy water no matter how much your filter runs. Typically filters hold sand in 50 lb. increments, so you can safely expect filters to range from 100, 150, 200, 250 lbs., etc.

How often should you change pool filter sand?

On average, sand should be replaced every 3-5 years. This may be longer if the pool stays clear, or shorter, if the filter runs all the time. The jagged edges of the sand wear down and become smooth as the sand ages.

Does sand damage pool pump?

Answer: Get as much of the debris and algae as you can out manualy (net, vacuum). You can also vacuum the sand, but make sure you vacuum to waste so it does not damage your pump/filter again.